Industry news

2016August

LED light emitting diode characteristic test (1)

From: www.szbako.com Data:07/08/2016

Abstract: using conventional experimental apparatus built LED characteristic testing system, testing the LED volt ampere characteristic, the intensity distribution and spectral properties, optical power and current characteristics and luminescent efficiency and current characteristics of the relation and the LED threshold value voltage and normal voltage and emission wavelength, half angle and point, peak wavelength and flux parameter.

/> 1 foreword

currently semiconductor light-emitting diode (LED) has been widely used in lights, instrument display, mobile phone backlight and vehicle light source lighting field. Build this led characteristic test system, with simple structure, strong comprehensiveness, advantages of low capital cost, direct measurement of LED volt ampere characteristic, the intensity distribution, spectral properties, optical power and current characteristics and luminescent efficiency and current characteristics; indirect calculation LED light-emitting wavelength and the normal working voltage and half angle, luminous flux and luminous efficiency. These work not only enrich the teaching content of the experiment, so that students can understand the basic concepts of electronic transitions, hole formation, light intensity, light intensity, etc., but also can thoroughly and comprehensively study the characteristics of LED.

/> 2 experimental

2.1 experimental equipment 2.2 design principle and method of

2 is measurement of LED light intensity distribution of the test system, take after led axis on a beta plane, the illumination surface measurement curve on the plane and the light source center distance of each point on the light intensity and to determine the intensity and LED light-emitting angle between the relationship of five kinds of LED light intensity distribution calculated by light-emitting diode half angle and directivity.

3 is TCS230 color sensor for measuring led normal luminescence spectral components under the condition of the system diagram, will test the standard parameters of test results and monochromator compared and test its accuracy; according to the calculated peak wavelength, examine the LED luminescence purity.

Figure 4 is the measurement of the optical power of LED and the current relationship between the characteristics of the circuit diagram, through the data analysis of the current LED emission consistent.

5 is led luminous flux measurement experimental system, the illuminance meter accept top surface and measured led to the top contact, by adjusting the current illumination table readings in order to analyze the different current of luminous efficiency and make the glow curve of relation between the current efficiency and.

RELATED NEWS